Plat - Platinum (White Gold), 2g

Liquid Metallics, Colorobbia

** Safety: Use in a well-ventilated area; wearing a respirator is highly recommended due to hazardous fumes during the firing process. Avoid contact with skin.

♦

Application: Apply a thin, smooth coat using a clean brush or outline pen to surfaces that are completely cool, clean, and dry.

Ceramic Firing: Typically fires at approximately 1166°F (or within a range of 1333°F to 1386°F) depending on the clay body and desired outcome.

Glass Firing: Matures around 1166°F (Cone 022) on previously fired glass. Target temperatures may vary from 1200°F to 1330°F for slumping or higher for fusing.

♦

Tips for Fired Glass:

Heat slowly to prevent thermal shock and cracking.
Monitor kiln temperatures closely throughout the cycle.
Controlled Annealing: Cool slowly to relieve stress and ensure durability.

♦

Bright Gold (8%): A classic option that provides a rich, elegant 18-23 karat film when fired at approximately 1166°F.

Bright Platinum (White Gold): Delivers a sophisticated silver-toned finish for a modern, sleek aesthetic.

♦

Ventilation: Always vent the kiln (propped lid or fan) up to 1000°F to allow organic binders to burn off cleanly.

Overglaze Thinner, Colorobbia

Colorobbia Thinner (4 oz / 100g) is the essential solution for cleaning brushes and tools used with metallic overglazes and lusters.

Colorobbia Overglaze Thinner serves a dual purpose: cleaning brushes and tools and acting as a "luster essence" to restore the flow of thickened overglaze, with users advised to add no more than 3% thinner for restoration and to never use water. 

♦

High Compatibility: Designed by Colorobbia in Italy specifically for their line of Gold, Platinum, and Mother of Pearl overglazes.

♦

Size: Large 4 oz (100g) bottle (oversized for safety; bottle may not appear full).

♦

Restoring Thickness: If the gold becomes tacky or thick due to evaporation, add 1–2 drops of Colorobbia Thinner and mix thoroughly. Do not exceed 3% thinner.

♦

Viscosity Control: Acts as a "luster essence" to restore smooth flow if your gold becomes tacky or thick from air exposure.

♦

Cleaning: Use the same thinner to clean brushes and tools immediately after use.

♦

Mistakes: Before firing, use a Q-tip dampened with alcohol or essence to wipe away errors. 

♦

Pro Tip: Never use water to thin metallic overglazes; it will cause the gold to separate and ruin the finish.