)
)
)
)
)
)
)
Dust Filters for 6200M, 2091
Item#: 2020
- 3M Particulate Filter 3M2091, P100 is NIOSH approved for environments containing certain oil and non-oil based particles up to 10 times OSHA PEL with half face pieces or 50 times PEL with full face pieces.
- Full face pieces must be quantitatively fit tested to claim assigned protection factor above 10 in negative pressure mode. against exposure to lead, asbestos, cadmium, arsenic and MDA.
- Compatible with a variety of 3M half and full face pieces, for use in a variety of applications including: welding, brazing, torch cutting, metal pouring and soldering. 2 Each Per Bag.
Important information
Safety Information
* Use with appropriate 3M half and full face pieces in hazardous environments containing oil or non-oil based particles.
* Full face pieces must be quantitatively fit tested for assigned protection factor above 10 in negative pressure mode against lead, asbestos, cadmium, arsenic and MDA.
♦
Directions
1. Prepare the filter by checking for any damage or defects. Ensure it is the correct model for your 3M mask.
2. Before inserting the filter, clean your mask if necessary. Make sure there is no dirt or debris that could interfere with the seal.
3. Insert the filter into the mask, ensuring it clicks or locks into place securely.
4. Check for an airtight seal by covering the mask's exhalation valve and inhaling. The mask should pull slightly towards your face.
5. Recommended usage duration before replacement varies based on the environment and exposure levels; consult the filter's data sheet or user manual for specific guidance.
Share:
Share on Facebook Share on Twitter Share on Pinterest Tell a friend