)
)
Skutt
0991 - Sensing Rod, 9"
Skutt Replacement Part
Item#: SR1
MPN: 0991
- Skutt sensing rod for use with Skutt kilns with 3" brick.
** Please measure your old sensing rod to ensure you're ordering the correct length.
- The sensing rod passes through the tube assembly and applies its weight to the small cone. This is a critical piece of the dawson sitter system, and these rods can bend over many years of use.
- You can make sure your sitter is calibrated properly by using a gauge washer
Item#: SR1
MPN: 0991
- Skutt sensing rod for use with Skutt kilns with 3" brick.
** Please measure your old sensing rod to ensure you're ordering the correct length.
- The sensing rod passes through the tube assembly and applies its weight to the small cone. This is a critical piece of the dawson sitter system, and these rods can bend over many years of use.
- You can make sure your sitter is calibrated properly by using a gauge washer
Tube Assembly Replacement - PDFs
PDF - Type K Shut Off Tube Assembly Replacement
These instructions are for replacing Shut Off Tubes in all Skutt KilnSitter kilns.
♦
PDF - Type P Shut Off Tube Replacement
These instructions are for replacing Type P Shut Off Tubes which are often used in non-Skutt Kiln Models.
Share:
Share on Facebook Share on Twitter Share on Pinterest Tell a friend